Zeta NPAD 2 Installation Manual

Also see for Premier AD: User manual, maintenance guide & log book User manual, maintenance guide & log book Installation manual

Zeta NPAD 2 Installation Manual Manual pdf 8 page image

PREMIER AD INSTALLATION MANUAL. Software Version :PANEL-R1578 & LOOP-R1062Approved Document No: GLT.MAN-105A PAGE 7Issue : 2.02 Authorised: GH Date: 16/07/20075. MOUNTING THE FIRE ALARM PANELThe Premier AD comes with many cable entry holes. If another entry hole is required, it is stronglyrecommended that the panels door be removed to avoid accidental damage. Also, the terminationPCB should be removed and stored in a safe place. This would also help while fixing the back box tothe wall.5.1 PLANNING CABLE ENTRYFig.2 below shows the location of the cable entries to facilitate planning of wiring (home runs) to bebrought to the panel.The grommets can be easily removed by a push from inside the control panel box.If a grommet is removed, fill the hole with a brass cable gland. If any knockout is removed, butsubsequently not used, it should be covered up.The 230Va.c. Mains cable must be fed into the enclosure via one of the cable entries at the top rightcorner of the back box. (Refer to “Connecting the Mains” on Page 8).5.2 FIXING THE BACK BOX TO THE WALLFigure 2: Plan view inside the enclosure without PCBs. Side view for surface installation.485mm 100mm395mm430mm275mmWall Mount Flush Mount73mm95mmFix the enclosure to the wall using the three mounting holes provided.Check the build & condition of the wall to decide a suitable screw fixing.The mounting holes are designed for No 8 roundhead or countersunk woodscrews (or similar).Remove any debris from the enclosure.Take care not to damage the FACP during installation.