u Models 5A0125 to 5A0242 (IP00/Open Type Enclosure)n Removing the Terminal Cover1. Loosen the screws on the terminal cover, then pull down on the cover.Note: The terminal cover and the number of terminal cover screws differ depending on the drive model.CAUTION! Do not completely remove the cover screws, just loosen them. If the cover screws are removed completely, the terminalcover may fall off causing an injury.Figure 3.10 Removing the Terminal Cover on an IP00/Open Type Enclosure Drive2. Pull forward on the terminal cover to free it from the drive.Figure 3.11 Removing the Terminal Cover on an IP00/Open Type Enclosure Driven Reattaching the Terminal CoverAfter wiring the terminal board and other devices, double-check connections and reattach the terminal cover. Refer to Wiringthe Main Circuit Terminal on page 85 and Wiring the Control Circuit Terminal on page 89 for details on wiring.<1>Figure 3.12 Reattaching the Terminal Cover on an IP00/Open Type Enclosure Drive<1> Connect the ground wiring first, then the main circuit wiring, and finally the control circuit wiring.3.5 Terminal CoverYASKAWA TOEP YAIZ1U 03B YASKAWA AC Drive – Z1000 User Manual 773 Electrical Installation
