Xerox phaser 3635 Service Manual

Also see for PHASER 3635: User guide System administration guide Service manual

Contents

Xerox phaser 3635 Service Manual Manual pdf 62 page image

3-14 Phaser 3635MFPIQ11, IQ12Draft 4Image QualityIQ11 Stains on Back of Paper RAPUse this RAP when the printed sheets have stains on the non-image side of the paper.ProcedureWARNINGSwitch off the electricity to the machine. Disconnect the power cord from the customersupply while performing tasks that do not need electricity. Electricity can cause death orinjury. Moving parts can cause injury.Perform the following:1. Check the transfer roll, PL 9.10 Item 2. Clean as required or install a new transfer roll, PL9.10 Item 2.2. Check the paper path for dirt and contamination. Clean as required.3. Check the fuser assembly for contamination. Install new components as necessary, PL10.10 to PL 10.15.IQ12 Poor Fusing RAPUse this RAP when the image is improperly fused.ProcedureWARNINGSwitch off the electricity to the machine. Disconnect the power cord from the customersupply while performing tasks that do not need electricity. Electricity can cause death orinjury. Moving parts can cause injury.WARNINGDo not touch the fuser while it is hot.Perform the following:1. Ensure that the paper tray settings match the paper or media size in the trays. Alsoensure the media is within specification. Refer to GP 9 Paper and Media Specifications.2. Examine the fuser assembly PL 10.10. Ensure the thermistor PL 10.12 Item 16 is cleanand in good contact with the fuser.3. Ensure the machine is being operated in the correct environmental conditions. Refer toGP 7 Machine Specifications.4. If the machine has been standing in a low temperature environment for a long time, try tobring the environment up to a warmer temperature before re-trying the machine.5. Refer to Wiring Diagram 1. Perform the following:• Check the wiring between CON2 on the SMPS and the fuser assembly.• If necessary, install a new SMPS, PL 1.12 Item 3.6. If necessary, go to the 10-100, 200 Open Fuser Error/Low Heat Error RAP.