Network Connectivity42 WorkCentre 7800 Series Multifunction PrinterSystem Administrator GuideConfiguring SNMP Advanced SettingsYou can add, edit, or delete IP and IPX addresses for Network Management workstations that receivetraps from the printer.Configuring SNMP Advanced Settings1. In CentreWare Internet Services, click Properties > Connectivity > Setup.2. Under Protocol, next to SNMP, click Edit.3. Click Advanced Settings.4. To add an IP trap destination address, under Trap Destination Addresses, click Add IP Address.5. To add an IPX trap destination address, under Trap Destination Addresses, click Add IPX Address.6. To edit an address, next to the address click Edit.7. To delete an address, select the check box next to the address and click Delete.Adding or Editing an IP Trap Destination Address1. On the Advanced Settings page, click Add IP Address, or select an existing address and click Edit.2. Type the IP address of the host running the SNMP manager that receives traps.3. Type the UDP Port Number. The default is 162 for traps.4. Select the SNMP version based on what the system receiving traps supports.5. Select the type of traps that the SNMP manager receives under Traps to be Received.6. Click Save to apply the new settings or Undo to retain the previous settings.7. Click Cancel to return to the previous page.Adding or Editing an IPX Trap Destination Address1. On the Advanced Settings page, click Add IPX Address, or select an existing address and click Edit.2. Type the 8-digit hexadecimal number that identifies the IPX External Network host configured toreceive the trap.3. Type the 48-bit Physical MAC Address of the computer running the SMNP manager applicationreceiving the trap.4. Type the IPX Socket Number of the computer running the SNMP manager application configured toreceive the packets. The default IPX Socket Number is 9010.5. Select the SNMP Version.6. Select the type of traps that the SNMP manager receives under Traps to be Received.7. Click Save to apply the new settings or Undo to retain the previous settings.8. Click Cancel to return to the previous page.
