1 Welcome12 Xerox WorkCentre 4250/4260 User GuideThis product has been manufactured under a registered ISO9001 Quality system.CE MarkThe CE mark applied to this product, symbolizes XEROX's declaration ofconformity with the following applicable European Union Directives, as of thedates indicated:December 12, 2006:Council Directive 2006/95/EC as amended. Approximation of the laws of themember states related to low voltage equipment.December 15, 2004:Council Directive 2004/108/EC as amended. Approximation of the laws of themember states related to electromagnetic compatibility.March 9, 1999Council Directive 99/5/EC, on radio equipment and telecommunicationsterminal equipment and the mutual recognition of the conformity.A full declaration of conformity, defining the relevant directives and referencedstandards, can be obtained from your XEROX Limited representative.WARNING: In order to allow this equipment to operate in proximity toIndustrial Scientific and Medical (ISM) equipment, the external radiation fromthe ISM equipment may have to be limited or special mitigation measurestaken.NOTE: Changes or modifications to this equipment not specifically approved bythe Xerox Corporation may void the user’s authority to operate this equipment.WARNING: Shielded cables must be used with this equipment to maintaincompliance with Council Directive 2004/108/EC.EMC InformationFCC Part 15This equipment has been tested and found to comply with the limits for a Class Adigital device, pursuant to Part 15 of the FCC Rules. These limits are designed toprovide reasonable protection against harmful interference when the equipmentis operated in a commercial environment. This equipment generates, uses and canradiate radio frequency energy and, if not installed and used in accordance withthe instruction manual, may cause harmful interference to radio communications.Operation of this equipment in a residential area is likely to cause harmfulinterference in which case the user will be required to correct the interferences attheir own expense.
