11 SetupsXerox WorkCentre 4250/4260 User Guide 179Change Default SettingsChanging the user defaults to reflect the needs of the users will make the machinemore user-friendly, increasing effectiveness and productivity.Set (Power Save) Duration TimesThis utility enables the System Administrator to modify the default 30 minutes themachine will spend between standby and low power modes.The machine is designed to be energy efficient and will automatically reduce itspower consumption after periods of inactivity.To change the elapsed time for the machine to go from Standby Mode to LowPower Mode, select the appropriate time frame, e.g. after 5 minutes duration, after45 minutes duration, etc.Select the Save button to confirm the change.Tools > Device Settings > General > Energy SaverEntry Screen DefaultThis feature enables the machine administrator to set which screen the user seesfirst.The Entry Screen appears when the machine resets selections after a user hascompleted a job, or after the Clear All button is pressed. The available options areFeatures, Job Status, Machine Status and All Services. To set one of the options,touch the appropriate button and then select Save.Tools > User Interface > General > Screen Defaults > Entry Screen DefaultJob Status DefaultUse this feature to set the default screen when the user presses the Job Statusbutton to the left of the UI. For a full list of available screens, refer to Job StatusScreen in the Copy chapter on page 41.Tools > User Interface > General > Screen Defaults > Job Status DefaultFeature Default and PriorityUse this feature to change the priority of the Copy, ID Card Copy, NetworkScanning, Fax and E-mail features.The highest priority service will be displayed as the default service on the machine.Any remaining services will be accessible through the Services Home button.Tools > User Interface > General > Screen Defaults > Feature Default andPriority
