Xerox DocuPrint N2125 System Administrator Manual

Also see for DocuPrint N2125: Product reference guide Specification sheet User guide User guide Service manual

Contents

Xerox DocuPrint N2125 System Administrator Manual Manual pdf 140 page image

Configuring Automatic Tray Switching1-124 v System Administrator GuidePaper Size/TypeMismatchPaper size/type mismatch occurs when the requested sizeis not available in the printer. This can be caused byrunning out of paper in a tray that is configured for therequested paper, or by requesting a paper that is notconfigured in the printer. The printer goes off-line underpaper mismatch conditions. It automatically returnson-line and continues printing after the paper mismatchcondition is resolved.If a tray is configured for the requested paper, but the trayis out of paper, the display prompts you to load therequested paper (size and type) in the appropriate tray.After the tray is loaded, printing continues.If the request is for paper that is not configured in theprinter, you are prompted to load the requested paper inthe first tray of the Tray Sequence setting.If you do not want to load paper in the first tray of theTray Sequence setting, two options are available:• One of the trays may be loaded with the requested sizepaper and reconfigured via the Tray Menu to matchthe requested paper type. (See Table 1.10 on page 1-24for instructions on using the Tray Menu.)• Value Up or Value Down may be pressed to scrollthrough all the trays, displaying the size and typepaper in each tray. If one of these alternate papers isacceptable, pressing Enter will cause printing tocontinue on the new paper. Trays are searched in theorder specified in the Tray Sequence setting.