126 6 Daily Care6.8 Adjusting the Transfer VoltageWhen you get bad printing results such as having white spots on the printed image, spillingtoner out on the printout, or a bluish printout, adjust the transfer voltage to solve theseprinting problems.1. Press the 2. Press the < > or < > button until [Admin Menu] is displayed, then press the < > or button.3. Press the < > or < > button until [Maintenance Mode] is displayed, then press the< > or button.4. Press the < > or < > button until [Adjust BTR] is displayed, then press the < > or button.5. Press the < > or < > button until the paper type you want to set is displayed, thenpress the < > or button.6. Press the < > or < > button to set the value, then press the button. Youcan set the value between [-3] and [+3] in increments of 1. The default is [0].7. Press the 6.9 Adjusting the Fuser TemperatureWhen you get bad printing results such as printed images or texts coming off or doubleprinting with appropriate margins, adjust the fuser temperature to solve these printingproblems.To strengthen the fixing level and prevent text and images from coming off, set the fusertemperature higher.To avoid double printing, set the fuser temperature lower.1. Press the 2. Press the < > or < > button until [Admin Menu] is displayed, then press the < > or button.3. Press the < > or < > button until [Maintenance Mode] is displayed, then press the< > or button.4. Press the < > or < > button until [Adjust Fuser] is displayed, then press the < > or button.5. Press the < > or < > button until paper type to set is displayed, then press the < >or button.6. Press the < > or < > button to set the value, then press the button. Youcan set the value between [-2] and [+2] in increments of 1. The default is [0].7. Press the
