Xerox 721 Operator's Manual

Also see for 721: User guide Operator's manual Setup guide User guide Release note

Contents

Xerox 721 Operator's Manual Manual pdf 71 page image

USER MODESXEROX WIDE FORMAT 721P PRINTER OPERATOR MANUAL 63User Mode b (Image Enhancement) “Ub”The Image Enhancement Mode is used to improve reproduction ofgray scale. Increasing the setting of this feature increases thedensity of single pixels. There can be, however, a noticeableoverall degradation in gray scale images as the setting isincreased. Experimentation will be required to achieve the correctbalance.If an AccXES controller is used to print to the 721p and the versionof software is 9.2 or higher, than the setting of “Ub” should have noeffect on output quality. The output density can be changed onWebPMT on the AccXES controller. The setting to change thedarkness of printer output is the Toner Density setting on the webpage “Printer Defaults/Printer Setup/Miscellaneous”. The defaultsetting is 5 and can be adjusted from 1 (lighter) to 10 (darker).1) With the printer in the Standby (idle) condition, press the [Menu]Key 11 times to enter Mode b.The [Menu] Key lights and the display indicates “Ub”Press [Enter]2.) Press the → or ← key to change the value:0 = No Image Enhancement1 = Low Image Enhancement2 = Medium Image Enhancement3 = High Image EnhancementNOTE: Factory default is “0”, No Enhancement3) Press [Enter] key to store the value.4) Press the [Online] Key to exit the User Mode.Menu Enter OnlineMenu Enter OnlineMenu Enter OnlineMenu Enter Online

/ 72

Related manuals for Xerox 721