Xerox 721 Operator's Manual

Also see for 721: User guide Operator's manual Setup guide User guide Release note

Contents

Xerox 721 Operator's Manual Manual pdf 48 page image

PROBLEM SOLVING40 XEROX WIDE FORMAT 721P PRINTER OPERATOR MANUALClearing Media Jam (J-05)When a jam J-05 occurs, the media jams while feeding from theManual Bypass Shelf.1. Open the Right Side Door and turn the Inner TransportAssembly handle to release the transport. Lower and lock thetransport by engaging the Down Lock.2. If the media is not cut and the leading edge of the media hasreached the Drum or beyond the Drum, rotate the Cutterhandle to cut the media. Continue rotating the cutter handleso that the green home position indicator appears in the cutout.3. If the leading edge of the media has reached the Fuser Unit,open the Exit Cover and remove the jammed media by rotatingthe Fuser Handle.4. Release the Down Lock while holding the handle of InnerTransport Assembly and lift it up gently until it stops. Thentwist the handle to the left to move the transport to the homeposition. Finally, turn the handle to the right to lock thetransport.5. Pull to open the top drawer, middle drawer, and ManualBypass Shelf.6. Remove any media from the inside of the printer.7. Close and latch the drawers and Manual Bypass Shelf.8. Reload the media on the Manual Bypass Shelf, curl sidedown.MFD1D2D3 D4PFExitCopy Density Menu Enter OnlineFuserHandleCutterhandleInner Transport handleDown LockEX P-CLEANW IRE- CLEAND1MFD2D3 D4EXITPFCOPY DENSITY MENU EN TER RESET→← *PAPER DECKCUT S ELECT1 2 3 4