Xerox 6200DX - Phaser Color Laser Printer Network Manual

Also see for 6200DX - Phaser Color Laser Printer: Brochure & specs Setup and quick reference guide Paper guide Installation instructions Support guide

Contents

Xerox 6200DX - Phaser Color Laser Printer Network Manual Manual pdf 27 page image

Windows NT 4.x NetworkPhaser® 6200 Color Laser Printer 2213. Verify that the IP Address in the Print to the following port list is the same as the one from theConfiguration Pages. If necessary, re-select the TCP/IP number used for your printer.14. Click on the General tab, then click Print Test Page. If the printer still does not print, accessPhaserSMART from the Troubleshooting tab of your printer driver or refer to the Xerox web siteat: www.xerox.com/officeprinting/support.Windows NT 4.x troubleshooting (AppleTalk)This troubleshooting section assumes you have completed the following tasks: You have loaded a Phaser printer PostScript print driver. You have printed and retained a current copy of the Configuration Pages. For information onprinting Configuration Pages, refer to the Front Panel section of the Features Guide on theInteractive Documentation CD-ROM.1. Verify these items in the EtherTalk areas of the Configuration Pages: The EtherTalk Name is correct. Enabled is set to Yes. Zone contains the desired zone name or * (* = means default local zone).2. Verify that the client is logged into the network and printing to the correct print queue. Also verifythat the user has access to the Phaser printer queue.3. From the server desktop, use the right-mouse button and select Network Neighborhood. With theleft-mouse button, select Properties from the cascade menu.4. The Network dialog should appear. Select the Configuration tab.5. Check the list of installed network components for AppleTalk Protocol.6. As required, install any components not listed and restart the system.7. Once rebooted, select the Start button and Settings, then select the Printers folder. The Printerswindow should appear.8. Right-mouse-click on the printer icon and select Properties.9. Verify that you have selected the correct driver for your printer.10. Select the Ports tab.11. Verify the AppleTalk name in the Print to the following port list. If necessary, re-select thecorrect name or, if not listed, Add a new port, selecting the Zone, then the name, from Steps 1 and2 above.12. Click on the General tab, then click Print Test Page. If the printer still does not print, accessPhaserSMART from the Troubleshooting tab of your printer driver or refer to the Xerox web siteat: www.xerox.com/officeprinting/support.