80 • Special features keys XEROX WIDE FORMAT COPY SYSTEM4. Press the Enter key to select the setting.5. Change the setting as follows:• To change the “+” or “-“ setting, press the Previous or Nextkey. An edge of the image can be clipped by entering anegative margin value for that edge. In that case, theaffected edge is shown as a dotted line and the image iconis shown as partially outside the bounds of the media.The illustration below shows a negative left margin with TOPLEFT justification.LEAD + 2.0 INLEFT - 1.0 INRIGHT + 0.0 INTRAIL + 0.0 INMargins Selection Screen in Transform Menu• To change the value setting, use the numeric keypad toenter the value. The values can be set in increments of 0.1in (1.0 mm) and over a range of +8 to -8 in (+203 to -203mm). Values outside the allowed range are rejected. If youenter an invalid value, press the Exit key to clear it. Thedefault margins are 0.6. Press the Enter key to confirm the setting. The graphical displayupdates accordingly.NOTE: To cancel the setting, press the Exit key.7. When you have set all the margins as desired, press the Exitkey to return to the TRANSFORM MENU screen.The JUSTIFICATION option of the TRANSFORM MENU allows you toadjust the position of the image on the media.NOTE: “Image” means the entire scanned page including the whitespace.To specify the image position:1. Press the Transform key. The TRANSFORM MENU screen isdisplayed.2. Press the Next key to highlight JUSTIFICATION.3. Press the Enter key to select JUSTIFICATION. TheJUSTIFICATION screen is displayed. This screen shows thecurrent settings for the X and Y coordinates. It also includes agraphical display of the approximate position of the image as aresult of the settings.Justification
