XEROX WIDE FORMAT COPY SYSTEM Scanning to the Network (SCAN mode) • 91select single bit preview image scaling, and with Accxes 12.5,the system produces improved preview images for both Normaland Line modes.3. With READY TO COPY is displayed on the Scan System ControlPanel, press the Mode key to display READY TO SCAN.4. Use the keypad on the Scan System Control Panel to enter inyour 16 alphanumeric character Scan Directory name.5. To view a sample of the file before it is scanned to a file, pressthe Sample key on the Control Panel. Use the Next or Previouskey to highlight SCAN-TO-PRINTER and press the Enter key.Press the Exit key to return to the READY screen, then pressStart. A copy will be sent to the printer.6. When the Scan System Control Panel displays READY TOSCAN, select your desired scanning resolution using the Nextand Previous keys.NOTE: When making a color scan, be sure to select Color with thearrow key under Image Quality on the Scan System Control Panel. TheNormal and Photo lights will be on.7. Select the Image Quality, Original, Type by pressing the arrowbutton located under Type. When the Type (Normal, Line,Photo, or Color) is selected, the appropriate SCAN OPTION(NORMAL, LINE, PHOTO, or COLOR) is displayed. Use theNext, Previous, and Enter keys to navigate to and through theavailable options on the screen. Press the Enter key to confirmyour choice(s). For additional information refer to the “ImageQuality, Scan Mode” section of this manual.8. Insert your original document face down and centered on thefeed tray of the Scan System.9. Gently move your document forward until the Scan System’sfeed rolls engage the document’s leading edge.10. If prompted to do so, enter the desired scanning width and pressEnter.11. As your document is automatically fed into the Scan System, theresulting image is stored as a file in the Scan Directory on thesystem Controller’s hard drive. The image can be retrieved atyour workstation using the Document Retrieve Tool of theFreeFlow Accxes Client Tools.NOTE: You may have to press the Start button if the configuration (forAuto Scan) has been changed from the factory default.
