5 PARAMETERS MENUThe HVAC Application has the following parameter groups:Menu and Parameter group DescriptionGroup 3.1: Motor settings Basic and advanced motor settings.Group 3.2: Start/Stop setup Start and stop functions.Group 3.3: Control reference settings Frequency reference setup.Group 3.4: Ramp & Brakes Setup Acceleration/Deceleration setup.Group 3.5: I/O Configuration I/O programming.Group 3.6: Fieldbus Data Mapping Fieldbus data out parameters.Group 3.7: Prohibit Frequencies Prohibit frequencies programming.Group 3.8: Limit supervisions Programmable limit controllers.Group 3.9: Protections Protections configuration.Group 3.10: Automatic reset Auto reset after fault configuration.Group 3.11: Timer functions Configuration of 3 timers based on Real Time Clock.Group 3.12: PID-controller 1 Parameters for PID Controller 1. Motor control orexternal usage.Group 3.13: PID-controller 2 Parameters for PID Controller 2. External usage.Group 3.14: Multi-pump Parameters for multi-pump system.Group 3.16: Fire mode Parameters for Fire Mode.Group 3.17 Application SettingsGroup 3.18 kWh Pulse Output Parameters to configure a digital output that givespulses that agree to the kWh counter.5.1 GROUP 3.1: MOTOR SETTINGSNOTE!These parameters are locked if drive is in the run state.VACON · 54 PARAMETERS MENU5 TEL. +358 (0)201 2121 · FAX +358 (0)201 212 205
