Table 49: The basic I/O parameters in the I/O and Hardware menuIndex Parameter Min Max Unit Default ID DescriptionV5.1.11 Analogue Output 1Mode 1 3 1Shows the mode that isset for the analogueinput signal. The selec-tion is made with a DIPswitch on the controlboard.1 = 0...20mA3 = 0...10VV5.1.12 Analogue Output 1 0 100 % 0.00 Status of the analogueoutput signalV5.1.13 Relay Output 1 0 1 0 Status of the relay out-put signalV5.1.14 Relay Output 2 0 1 0 Status of the relay out-put signalV5.1.15 Relay Output 3 0 1 0 Status of the relay out-put signal7.2 OPTION BOARD SLOTSThe parameters in this menu are different for all the option boards. You see the parametersof the option board that you installed. If there is no option board in the slots C, D or E, you donot see parameters. See more about the location of the slots in Chapter 9.5 I/O configuration.When you remove an option board, the fault code 39 and the fault name Device removed showon the display. See Chapter 10.3 Fault codes.Table 50: Option board related parametersMenu Function DescriptionSlot CSettings The settings that are related to the option boardMonitoring Monitor the data that is related to the option boardSlot DSettings The settings that are related to the option boardMonitoring Monitor the data that is related to the option boardSlot ESettings The settings that are related to the option boardMonitoring Monitor the data that is related to the option boardI/O AND HARDWARE MENU VACON · 11324-HOUR SUPPORT +358 (0)201 212 575 · EMAIL: VACON@VACON.COM 7
