Ublox TOBY-R2 Series System Integration Manual

Also see for TOBY-R2 Series: User guide

Contents

Ublox TOBY-R2 Series System Integration Manual Manual pdf 133 page image

TOBY-R2 series - System integration manualUBX-16010572 - R10 Approvals Page 133 of 1514.2.3 ModificationsThe FCC requires the user to be notified that any changes or modifications made to this device thatare not expressly approved by u-blox could void the user's authority to operate the equipment.⚠ Manufacturers of mobile or fixed devices incorporating the TOBY-R2 series modules areauthorized to use the FCC Grants of the TOBY-R2 series modules for their own final productsaccording to the conditions referenced in the certificates.⚠ The FCC Label shall in the above case be visible from the outside, or the host device shall bear asecond label stating:"Contains FCC ID: XPY1EHM44NN" resp."Contains FCC ID: XPY1EHQ24NN" resp.⚠ IMPORTANT: Manufacturers of portable applications incorporating the TOBY-R2 series modulesare required to have their final product certified and apply for their own FCC Grant related to thespecific portable device. This is mandatory to meet the SAR requirements for portable devices.Changes or modifications not expressly approved by the party responsible for compliance couldvoid the user's authority to operate the equipment.⚠ Additional Note: as per 47CFR15.105 this equipment has been tested and found to comply with thelimits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designedto provide reasonable protection against harmful interference in a residential installation. Thisequipment generates, uses and can radiate radio frequency energy and, if not installed and usedin accordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation. If thisequipment does cause harmful interference to radio or television reception, which can bedetermined by turning the equipment off and on, the user is encouraged to try to correct theinterference by one or more of the following measures:o Reorient or relocate the receiving antennao Increase the separation between the equipment and receivero Connect the equipment into an outlet on a circuit different from that to which the receiver isconnectedo Consultant the dealer or an experienced radio/TV technician for help