U-Line CLR2060 Installation Manual

Also see for ECHELON CLR2060: Supplementary guide Supplementary guide Supplementary guide Service and parts manual User manual

Contents

U-Line CLR2060 Installation Manual Manual pdf 17 page image

CLR2060 — Clear Ice Maker02/2005 17 www.U-LineService.com™2. If the ice maker is not level, adjust the feet on thecorners of the unit as necessary (see Figure 44).3. Check the levelness after each adjustment and repeatthe previous steps until the unit is level. Go on to9 Install the Unit.Installation TipIf the room floor is higher than the floor in the cut-outopening, adjust the rear feet to achieve a total unit rearheight of 1/8 " less than the opening’s rear height. Shortenthe unit height in the front by adjusting the front feet.This allows the unit to be gently tipped into the opening.Readjust the front feet to level the unit after it is correctlypositioned in the opening.Installation of the CLR20601. Open the water supply valve in the main water source.2. Plug in the power cord.3. Gently push the unit into position. Be careful not tokink the drain or water supply line or entangle theelectrical cord.4. Re-check the leveling, from front to back and side toside. Make any necessary adjustments. The unit’s topsurface should be approximately 1/8" below thecountertop.5. Test the drain system by pouring one gallon of waterinto the ice bin. The water should drain freely and thereshould be no leakage.Turn Foot to AdjustFigure 449 Install the Unit

/ 20

Related manuals for U-Line ECHELON CLR2060