U-Line CLR2060 Installation Manual

Also see for ECHELON CLR2060: Supplementary guide Supplementary guide Supplementary guide Service and parts manual User manual

Contents

U-Line CLR2060 Installation Manual Manual pdf 11 page image

CLR2060 — Clear Ice Maker02/2005 11 www.U-LineService.com™3. Install the pivot post into the new Replacement BottomHinge (using the 7/64" hex key or Phillips screwdriver)and install the hinge onto the unit.4. Replace the door closure assembly onto the bottompivot post (see Figure 25). Be sure that bosses onclosers align with holes in hinge and hinge plate.IMPORTANTPivot posts must be cleaned. Closers must also be cleanand greased to ensure proper operation.5. Place the modified door onto the pivot post.6. Position door and install the pivot post into the tophinge (using the 7/64" hex key or Phillips screwdriver).7. Adjust door as needed for proper closure. Go on to 5Adjust Door.Checking Door AlignmentThe unit’s door is aligned at the factory before shipment.However, its alignment could have been disturbed duringshipment or during door panel installation.IMPORTANTProperly aligned, the door should be 1/8" below the top ofthe unit’s cabinet, NOT flush with the top (see Figure 26).1. Compare the top edge of the door to the top edge ofthe cabinet.2. If the door edge is 1/8" below and parallel to the top ofthe cabinet, go on to 6 Prepare Plumbing. If it is not,note whether the side opposite the hinge needs to bemoved UP or DOWN, and use the following procedure.Adjusting Door Alignment1. Remove top hinge screwpin (7/64 " Allen wrench orPhillips screwdriver,depending on your unit’sconstruction, see Figure27). Remove door bytilting forward and liftingoff bottom hinge pin.2. With door upside-down,loosen but do not removethe two screws on thedoor’s bottom hinge plate.Top Pivot PlateDoor PanelWood Panel Top Hinge Plate(5/8" Longer than Existing Top Hinge Plate)#8-32 x 1/2"Flat Head ScrewThree PlacesPivot PostFigure 24Wood Panel Bottom Hinge Plate(5/8" Longer than Existing Bottom Hinge Plate)#8-32 x 1/2" Flat Head ScrewThree PlacesDoor Closure TopDoor Closure BottomPivot PostBossBossExistingDoorFigure 255 Adjust Door1/8"Figure 26Figure 27