U-Line 2015WC Wine Captain Installation Manual

Also see for 2015WCOL Wine Captain: Supplementary guide Supplementary guide Features & benefits User manual Hardware installation guide

Contents

U-Line 2015WC Wine Captain Installation Manual Manual pdf 7 page image

02/2005 7 www.U-LineService.com™ 2015WC/2015WCOL Wine Captain ®Side-By-Side InstallationInstructionsFor a complete refreshment center, install your 2015WC or2015WCOL unit beside a U-Line Refrigerator, Ice Maker orCombo Model (see Figure 11 for typical cut-out). Notethat each Side-By-Side Installation will be different.• Cut-out width for a side-by-side installation is the totalof the widths listed under Cut-Out Dimensions in eachunit’s Installation Guide.For example:Placing a 2015 Wine Captain ® next to a 2015 series unitwould require a cut-out width of:15-3/16" + 15-3/16" = 30-3/8"Placing a 2015 Wine Captain ® next to a 2075 series unitwould require a cut-out width of:15-3/16" + 24-3/16" = 39-3/8"• No trim kit is required. However, 1/4-inch space needs tobe maintained between the units to ensureunobstructed door swing.• Units must operate from separate, properly groundedelectrical receptacles placed according to each unit’sElectrical Specifications.The U-Line Wine Captain® is equipped with wood-trimmed wine racks that are coated at the factory with aclear vinyl sealer, which will adequately protect the woodin normal usage. A final finish coat was not applied sothat the wood trim could be stained to match décor oroverlay frame. The trim on the racks may be coated with afinal finish or stained.2015WCOL Models are designed for, and requireinstallation of, an Overlay Frame.If none of these treatments are to be included in thisinstallation, go on to 5 Adjust Door.CAUTIONTo prevent permanent damage to the inner liner of theWine Captain® , the wine rack wood trim MUST beremoved from the unit for staining and/or finishing.Allow stain/finish to dry thoroughly (at least 24 hours percoat) in accordance with the stain/finish manufacturer’sinstructions prior to re-installing the wood trim inside thecabinet of the Wine Captain® . Failure to do so may causethe inner liner of the unit to have a permanent odor,which is not covered by the warranty.Adding a Final Finish Coat to WoodTrim1. Remove each wine rack bysliding it out and up. SeeFigure 12.2. Remove and save screwssecuring wood trim to theracks.3. Lightly scruff sand thewood trim with 280 grit3M Tri-M-Ite sandpaper.4. Remove sanding dust witha tack cloth.5. Apply a thin coat of Minwax Polycrylic, followingcontainer label for directions. Allow to dry 24 hours.6. Lightly sand, tack and reapply 2 times, if desired.7. Allow the final coat to dry for 24 hours.8. Reinstall wood trim to wine racks using screwsremoved in Step 2.9. Reinstall wine racks in unit.10. For 2015WC units, go on to 5 Adjust Door.1"7"34-1/4"to35-1/8"1/4" SpaceBetween Appliances23-1/4"Figure 11Typical Side-By-Side Cut-Out4 Prepare Racks and Door FrameSlide Outand UpFigure 12