U-Line 2015WC Wine Captain Installation Manual

Also see for 2015WCOL Wine Captain: Supplementary guide Supplementary guide Features & benefits User manual Hardware installation guide

Contents

U-Line 2015WC Wine Captain Installation Manual Manual pdf 6 page image

2015WC/2015WCOL Wine Captain®www.U-LineService.com 6 02/2005™2. Remove plastic screw plugs (3 each, top and bottom)from new hinge location. Do not discard (see Figure 6).3. Remove top hinge (3 screws), reinstall hinge screw pin,and remount on opposite side BOTTOM (see Figure 7).4. Remove the two door closer inserts from the existingbottom hinge and install as shown on the new bottomhinge (see Figure 8).5. Remove existing bottom hinge (3 screws) and remounton opposite side TOP. Remove hinge screw pin.6. Remove the plastic hole plug from the top of the doorto allow the pivot pin to be inserted in the newlocation. Install the plug into the vacated hole on theopposite side.7. With bottom of door facing up, remove pivot plate(2 screws), flip over, and remount on opposite side ofdoor (see Figure 9). Be sure angled side of plate facescenter.8. Holding door upright with top of door tilted forward,place hole of door pivot plate on bottom hinge screwpin (see Figure 10).9. Tilt top of door intoposition in top hinge andinstall top hinge screw pin.10. Install plastic screw plugsremoved in Step 2 in oldhinge holes (3 each, topand bottom).Other Site RequirementsPower SupplyThe unit requires a grounded and polarized 115 VAC,60 Hz, 15A circuit (normal household current). SeeElectrical Specifications on Page 13.Environmental RequirementsThe surrounding air temperature must be at least 50°F(10°C) but must not exceed 110°F (40°C). The unit mustnot be located near heat-generating equipment or indirect sunlight.Screw PlugsFigure 5 Figure 6Figure 7 Figure 8HingeScrewPinDoorCloserInsertsFigure 9Figure 10