U-Line 2015WC Wine Captain Installation Manual

Also see for 2015WCOL Wine Captain: Supplementary guide Supplementary guide Features & benefits User manual Hardware installation guide

Contents

U-Line 2015WC Wine Captain Installation Manual Manual pdf 14 page image

2015WC/2015WCOL Wine Captain®www.U-LineService.com 14 02/2005™Anti-Tip Bracket Installation1. Locate two Anti-Tip Brackets included inside the unit.2. Place the unit into the area where it will be installed.Check the door, sides and top for a proper fit. Also testto make sure the door opens and closes freely.3. Remove grill and place a mark on the floor at the frontof the unit. Also place a mark on the floor in the centerof the unit. See Figure 30.4. Remove the unit. Using a square, extend a centerline20-1/4" toward the back wall. See Figure 31. At theback of the centerline, mark a line that measures6-9/16" to the left and right. This line serves as the backedge for the Anti-Tip Brackets and its furthest pointsmark the outer edge of each bracket.Note: Instructions are shown for built-in installation. Usesame dimensions for free-standing installation.5. Place the Anti-Tip Brackets on the floor against the linedrawn for the outer edge. Mark spots for the screwholes. See Figure 32.6. Use a 1/8" drill to make two starter holes and fasten theAnti-Tip Brackets to the floor using the screws provided.CAUTIONOther hardware is required for floors made of materialsother than wood.7. Place the unit back into position, making sure the feetengage the Anti-Tip Brackets properly. Check thealignment of the lines made on the floor in Step 3 withthe position of the front feet to ensure properpositioning.8 Install the UnitMarks on FloorFigure 3020-1/4"6-9/16" 6-9/16"BackWallCenterlineMarkson FloorLine MarksBackof UnitFrontof UnitFigure 31BackWallBackof UnitDrill Holes andMount Anti-TipBrackets to FloorFrontof UnitFigure 32

/ 16

Related manuals for U-Line 2015WCOL Wine Captain