9. From the [Print Server Information] menu, select [Print Server Configuration].10. From the [Print Server Configuration] menu, select [Printer Configuration].11. Select the printer indicated as [Not Installed].Use the same printer number specified as the remote printer number using SmartDeviceMonitor forAdmin.12. To change the printer name, enter a new name.A name “printer x” is assigned to the printer. The “x” stands for the number of the selected printer.13. As type, select [Remote Parallel, LPT1].The IRQ, Buffer size, Starting form, and Queue service mode are automatically configured.14. Press the [Esc] key, and then click [Yes] on the confirmation message.15. Press the [Esc] key to return to [Print Server Configuration Menu].16. Assign print queues to the created printer.17. From [Print Server Configuration Menu], select [Queues Serviced By Printer].18. Select the printer created.19. Press the [Insert] key to select a queue serviced by the printer.You can select several queues.20. Follow the instructions on the screen to make other necessary settings.Following these steps, check that the queues are assigned.21. Press the [Esc] key until “Exit?” appears, and then select [Yes] to exit PCONSOLE.22. Start the print server by entering the following from the console of the NetWare server.If the print server is in operation, quit and restart it.To quitCAREE: unload pserverTo startCAREE: load pserver [print server name]If the printer works as configured, the message “Waiting for job” appears.Setting up using Web Image Monitor1. Start Web Image Monitor.2. Click [Login].A dialog box for entering the login user name and login password appears.3. Enter the login user name and password, and then click [Login].For details about the login user name and password, consult your network administrator.4. Click [Configuration] in the left area, and then click [NetWare].4. Using a Printer Server1344
