Toshiba e-STUDIO203 Service Handbook

Also see for e-STUDIO163: Specifications Operator's manual Service handbook Service handbook Service handbook

Contents

December 2005 © TOSHIBA TEC e-STUDIO163/203 ADJUSTMENT3 - 153[D] Image position adjustment of the secondary scanning direction(1) While pressing [0] and [5] simultaneously, turn the power ON. # (Adjustment Mode)(2) Place a ruler on the original glass with its leading edge pushed against the original scale on theleft.(3) Press [0] and [9] simultaneously to enter the normal mode.(4) Make a copy at the mode of A3 (LD), 100% and standard drawer of the equipment.(5) Press [0] and [5] simultaneously to enter the adjustment mode.(6) Measure the distance D from the leading edge of the paper to 10 mm of the copied image of theruler.(7) Check if the distance D is within the range of 10±0.5 mm.(8) If not, use the following procedure to change values and repeat the steps (3) to (7) above.(Adjustment Mode) # (Key in the code [305]) # [START]# (Key in a value (acceptable values: 51 to 206))# Press the [INTERRUPT] button (stored in memory: The density LED blinks.).# (“AJ” is dis-played.)* The larger the adjustment value is, the more the image is shifted to the trailing edge (0.064mm/step).Be sure not to perform any operations while the density LED is blinking.Fig. 3-1110 20 30 40DFeeding directionCopied image of the ruler06/04