| 
e-STUDIO163/203 ADJUSTMENT December 2005 © TOSHIBA TEC3 - 6(1) Perform the test print according to the following procedure.(3) Perform the same procedure for all paper sources.Note:Note:When paper thinner than specified is used, paper jams may occur frequently at the registrationsection. In this case, it is advisable to change (or reduce) the aligning amount.However, if the aligning amount is reduced too much, this may cause the shift of leading edgeposition. So, when adjusting the aligning amount, try to choose the appropriate amount whileconfirming the leading edge position is not shifted.* As a tentative countermeasure, the service life of the feed roller can be extended by increas-ing the aligning amount.(2) Check if any transfer void is occurring. Ifthere is a transfer problem, try the values indescending order as “31” # “30” # “29”···until the transfer void disappears. At thesame time, confirm if any paper jam occurs.Also, when the aligning amount has beenincreased, this may increase the scrapingnoise caused by the paper and the Mylarsheet as it is transported by the registrationroller. If this scraping noise is annoying, try todecrease the value.Fig. 3-6[0][5][POWER][POWER]OFF/ON(Exit)(Test print)< 0: Bypass, 1: Drawer, 2: PFU>(Stores in memory)(Code) [START] [START] Current valuedisplayed[INTERRUPT] [INTERRUPT] [Drawer number][4] [START](Sub-Code) ( ) Enter newvalue( )50mm - 100mmTransfer void06/04 |
