| 
e-STUDIO163/203 ADJUSTMENT December 2005 © TOSHIBA TEC3 - 8(6) After the adjustment for the code 411 is completed, apply the same adjustment value for thecode 410.(Adjustment Mode) # (Key in the code [410]) # [START]# (Key in the same value in the step 5 above)# Press [INTERRUPT] (Stored in memory).Note:Note:Make sure the first line of the grid pattern is printed out since the line is occasionally vanished.[C] Reproduction ratio of secondary scanning direction (Fine adjustment of main motor rota-tion speed (Copier/Printer))(1) While pressing [0] and [5] simultaneously, turn the power ON. # (Adjustment mode)(2) Press [1] # [INTERRUPT] # [Drawer number] (Select from 0: bypass, 1: drawer or 2: PFU.) #[START]. (A grid pattern with 10 mm squares is printed out. Use A3/LD from standard drawer ofthe equipment.)(3) Check the grid pattern on the test chart printed out and measure the distance C from the 10thline at the leading edge of the paper to the 30th line of the grid pattern.* Normally, the 1st line of the grid pattern is not printed.(4) Check if the distance C is within 200±0.5 mm.(5) If not, use the following procedure to change values and measure the distance C again.(Adjustment Mode) # (Key in code [421]) # [START]# (Key in a value (acceptable values: 0 to 255))# [INTERRUPT] (Stored in memory) # “AJ” is displayed# Press [1] # [INTERRUPT] #!Press [Drawer number] # [START]# (A grid pattern is printed out.)* The larger the adjustment value is, the longer the distance C becomes (approx. 0.125 mm/step).06/04 |
