Toshiba RAS-07BKV-E Installation Manual

Also see for RAS-07BAV-E: Installation manual Service manual Owner's manual Owner's manual

ENESFRITDEPTPLCZRUCRHUTRNLGRSVFINODKROBGEELVSKSI11OTHERSOTHERSGas Leak TestRemote Control A-B SelectionTo separate using of remote control for each indoor unit in case of 2 airconditioner are installed near.Remote Control B Setup.1. Press [RESET] button on the indoor unit to turn the air conditioner ON.2. Point the remote control at the indoor unit.3. Push and hold [CHECK] button on the Remote Control by the tip of thepencil. “00” will be shown on the display (Picture 1).4. Press [MODE] during pushing [CHECK]. “B” will show on the displayand “00” will disappear and the air conditioner will turn OFF. The RemoteControl B is memorized (Picture 2).Note : 1. Repeat above step to reset Remote Control to be A.2. Remote Control A have not “A” display.3. Default setting of Remote Control from factory is A.• Check the flare nut connections for the gas leak with a gas leak detectoror soap water.Check places forthe indoor unit.Check places forthe outdoor unit.• When two indoor units are installed in the same room or adjacent tworooms, if operating a unit, two units may receive the remote control signalsimultaneously and operate. In this case, the operation can be preservedby setting either one remote control to B setting. (Both are set to A settingin factory shipment.)• The remote control signal is not received when the settings of indoor unitand remote control are different.• There is no relation between A setting/B setting and A room/B room whenconnecting the piping and cables.1 2Test OperationTo switch the TEST RUN (COOL) mode, press [RESET] button for10 seconds. (The beeper will make a short beep.)Auto Restart SettingThe product was shipped with Auto Restart function in the off position.Turn it on as required.This product is designed so that, after a power failure, it can restart automaticallyin the same operating mode as before the power failure.InformationHow to set the Auto Restart1. Press and hold the [RESET] button on the indoor unit for 3 seconds toset the operation. (3 beep sound and OPERATION lamp blink 5 time/secfor 5 seconds)2. Press and hold the [RESET] button on the indoor unit for 3 seconds tocancel the operation. (3 beep sound but OPERATION lamp does notblink)• In case of ON timer or OFF timer are set, AUTO RESTARTOPERATION does not activate.OPERATION /RESET Button