Toshiba RAS-07BKV-E Installation Manual

Also see for RAS-07BAV-E: Installation manual Service manual Owner's manual Owner's manual

8ELECTRICAL WORKSELECTRICAL WORKSThe power supply can be selected to connect to indoor unit or outdoor unit. Choose proper way and connect the power supply and connecting cable by followthe instruction as following.Wiring ConnectionIndoor unit Outdoor unitValve coverTerminals blockHow to install the air inlet grille on the indoorunit• When attaching the air inlet grille, the contrary of the removed operation isperformed.Wiring of the connecting cable can be carried out without removing thefront panel.1. Remove the air inlet grille.Open the air inlet grille upward and pull it toward you.2. Remove the terminal cover and cord clamp.3. Insert the connecting cable (according to the local cords) into the pipehole on the wall.4. Take out the connecting cable through the cable slot on the rear panel sothat it protrudes about 20 cm from the front.5. Insert the connecting cable fully into the terminal block and secure ittightly with screws.6. Tightening torque : 1.2 N·m (0.12 kgf·m)7. Secure the connecting cable with the cord clamp.8. Fix the terminal cover and air inlet grille on the indoor unit.Cord clampTerminal coverScrewScrewsAir inlet grilleFront panel1. Remove the valve cover, the electric parts cover and the cord clamp fromthe outdoor unit.2. Connect the connecting cable to the terminal as identified by thematching numbers on the terminal block of indoor and outdoor unit.3. Insert the power cord and the connecting cable carefully into the terminalblock and secure it tightly with screws.4. Use vinyl tape, etc. to insulate the cords which are not going to be used.Locate them so that they do not touch any electrical or metal parts.5. Secure the power cord and the connecting cable with the cord clamp.6. Attach the electric parts cover and the valve cover on the outdoor unit.Model RAS-07BKV-E RAS-10BKV-E RAS-13BKV-EPower source 50Hz, 220 – 240 V Single phaseMaximum running current 5.0A 6.7A 7.1APlug socket & fuse rating 6.5A 8.5A 9.0APower supply cable H07RN-F or 60245 IEC66 (1.5 mm 2 or more)Connecting cable