Toro Multi Pro 5800-D Installation Instructions Manual

Installing the Bypass Hose1. Assemblethe90°barbedfittingofthebypasshose—2.5x 64 cm (1 x 25 inches) onto the quick-connect fittingat the bypass-shutoff valve (Figure 77 and Figure 78).Figure 77Figure 781. Quick-connect fitting(bypass-shutoff valve)3. Retainer2. 90° barbed fitting (bypasshose)2. Secure the 90° barbed fitting to the quick-connectfitting with the retainer that comes with the bypass anddrain-hose assembly (Figure 78).3. Secure the bottom of the bypass hose to the rear saddleplate of the machine (Figure 79) with the supportclamp, flange-head bolt (5/16 x 3/4 inch), and washer(5/16 inch).Figure 791. Washer (5/16 inch) 3. Rear saddle plate(machine)2. Flange-head bolt (5/16 x3/4 inch)4. Support clampInstalling the Drain Valve1. Assemble the cable of the lynch pin, flange-head bolt(5/16 x 1 inch), and flange locknut (5/16 inch) that youremoved in step 4 of Preparing the Machine (page 5) tothe hole 8 mm (5/16 inch) in the rear, outboard cornerof the sprayer-pump bracket (Figure 80 and Figure 81).Figure 8036