Toro Multi Pro 5800-D Installation Instructions Manual

Removing the Agitation Bypass andSprayer Supply Hoses1. Remove the retainer that secures the straight barbedfitting for the agitation bypass hose to the agitationbypass valve (Figure 36).Figure 361. 90° barbed fitting (agitationBypass Hose)4. Straight barbed fitting(agitation Bypass Hose)2. T-fitting (upper) 5. Agitation bypass valve3. Retainers2. Remove the retainer that secures the 90° barbed fittingfor the agitation bypass hose to the upper T-fitting(Figure 36).3. Remove the agitation bypass hose from the machine(Figure 36).4. Fully loosen the fly nut for the sprayer supply hosefrom the threaded fitting of the master control valve(Figure 37).Figure 371. Straight barbed fitting(sprayer supply hose)4. Threaded fitting (mastercontrol valve)2. Fly nut (sprayer supplyhose)5. Retainer3. Straight barbed fitting—flynut (agitation supply hose)6. T-fitting (sprayer pump)5. Remove the retainer that secures the straight barbedfitting of the sprayer supply hose and the T-fitting atthe sprayer pump (Figure 37).6. Remove the sprayer supply hose from the machine(Figure 37).Note: Retain the retainers that you removed in steps1, 2, and 5 for installation Installing the Section BypassHose (page 28) and 11 Installing the Manifold SupplyHose (page 28). You no longer need the agitationbypass and sprayer supply hoses.17