Toro Multi Pro 5800-D Installation Instructions Manual

13Installing the Section Bypassand Drain-Hose AssemblyParts needed for this procedure:1 Bypass and drain-hose assembly1 Support clamp1 Flange-head bolt (5/16 x 3/4 inch)1 Washer (5/16 inch)Installing the Tank Drain Hose1. Assemble the barbed fitting of the drain valve that youremoved in step 6 of 5 Removing the Bypass, Drain,and Agitation Components (page 13) to the drainhose—104 cm (41 inches) of the bypass and drain-hoseassembly (Figure 73).Figure 731. Drain valve 3. Drain hose—2.5 x 104 cm(1 x 41 inches)—bypassand drain-hose assembly2. Hose clamp2. Secure the drain valve to the hose with the hose clamp(Figure 73) that you removed in step 6 of 5 Removingthe Bypass, Drain, and Agitation Components (page13).3. Align the bypass and drain-hose assembly to the backof the machine (Figure 74).Figure 741. Drain-Hose Assembly4. Assemble the 90° hose fitting of the drain hose—2.5x 67 cm (1 x 26-1/2 inches) with adapter fitting at thebottom of the sprayer tank (Figure 75 and Figure 76).Figure 75Figure 761. Drain hose—2.5 x 67 cm(1 x 26-1/2 inches)3. 90° hose fitting2. Retainer 4. Adapter fitting (bottom ofthe sprayer tank)5. Secure the 90° hose fitting to the adapter fitting withthe retainer (Figure 76) that you removed in step 1 ofRemoving the Bypass and Drain Hoses (page 14).35