Toro Multi Pro 5800-D Installation Instructions Manual

Disconnecting the Wire Harness fromthe Sprayer Components1. At the back of the machine (between the right frametube and the right fender), disconnect the 3-pinconnector of the speed-sensor harness at the righthydraulic-traction motor from the 3-socket connectorof the rear wire harness (Figure 21).Figure 211. 3-socket connector (rearwire harness)3. Front of the machine2. 3-pin connector(hydraulic-motor harness2. At the back of the manifold mount, disconnect the3-socket connector from the agitation valve and the3-socket connectors from the 3 boom-section valves(Figure 22).Figure 221. 3-socket connectors(SPRAY GUN VALVE)3. 3-socket connector(AGITATION VALVE)2. 3-socket connectors(RIGHT SPRAY VALVE /CENTER SPRAY VALVE /RIGHT SPRAY VALVE)4. 3-socket connector(EDUCTOR VALVE)3. Remove the push-in fasteners that secure the rear wireharness to the holes at the forward side and lower plateof the manifold mount (Figure 23).Figure 231. Manifold mount (lowerplate)3. Push-in fasteners2. Manifold mount (forwardside)4. Rear wire harness4. For machines without the ultra-sonic boom kit—at theback of the machine, disconnect the following 2-socketconnectors (Figure 24) for the lift-cylinder manifoldas follows:• Right—up solenoid• Left—up solenoid• Enable solenoid• Right—down solenoid• Left—down solenoid12