Toro Groundsmaster 4100-D Service Manual

Also see for 30447: Operator's manual Installation instructions Installation instructions

Contents

Groundsmaster 4100--D/4110--DCutting Deck Page 8 -- 2SpecificationsMOUNTING: Cutting deck is supported by lift arms con-trolled with individual lift switches.CONSTRUCTION: Deck chamber is welded 12 gaugesteel construction reinforced with channels and plates.HEIGHT--OF--CUT RANGE: 1” to 5” (25.4 mm to 127mm) adjustable in 1/2” (12.7 mm) increments. Centerdeck height--of--cut adjustment is achieved by changingspacers on castor wheels and adjusting length of decksupport chains. Wing deck adjustment achieved bychanging spacers on castor wheels, re--positioning thecastor wheel axles in the castor forks and securing thecastor wheel bracket to the correct height--of--cut brack-et holes.DECK DRIVE: Closed loop hydraulic system operateshydraulic motor on each cutting deck section. Motordrives one spindle directly with remaining deck sectionspindle(s) driven by B section kevlar v--belt(s). Bladespindles are 1--1/4” (31.7 mm) shafts supported bygreaseable, tapered roller bearings.CUTTING BLADE: Cutting blade dimensions are 19”(483 mm) long, 2.5” (64 mm) wide and 0.250” (6.4 mm)thick. Anti--scalp cup installed on each cutting blade.Center deck includes three (3) blades and each wingdeck includes two (2) blades.WIDTH OF CUT: Front deck provides 54” (1372 mm)width of cut. Each side deck has 37” (940 mm) width ofcut. Total width of cut is 124” (3150 mm).DISCHARGE: Clippings are discharged from the rear ofthe cutting deck.SUSPENSION SYSTEM: A fully floating suspensionwith hydraulic counterbalance. Front deck suspendedfrom lift arms and has six castor wheels, two adjustableskids and five anti--scalp rollers.