Toro 30582 Operator's Manual
Also see for 30582 Groundsmaster 580-D: Operator's manual
42• Clamp off the hose on each side of the fuel filter toprevent gas from pouring out of the hoses when youremove the filter.• Place a drain pan under the filter.• Loosen the screw and nut securing the fuel filtermounting clamp to the mounting plate (Fig. 41).• Loosen the hose clamps and slide them away fromthe filter (Fig. 41).• Remove the filter from the fuel lines.• Install a new filter and move the hose clamps closeto the filter. Make sure flow direction arrow pointstoward the engine.4. If the fuel system becomes contaminated or if machineis to be stored for an extended period, drain fuel tank bypumping fuel out the top of the tank. Clean tank andflush it with clean fuel.Important Following the maintenance steps listedabove will, under normal conditions, keep the systemtrouble-free. However, if the indicator light on the controlpanel and audible warning signal activate during operation,the engine should be stopped and the fuel system servicedbefore operation is resumed. This can prevent seriousengine damage from occurring.Engine Cooling SystemThe cooling system holds approximately 3.9 gal (14.7 l) ofa 50/50 solution of ethylene glycol anti–freeze and water.To properly maintain the system, use the followingprocedures:1. Check coolant level each day before starting the engine;refer to Check Cooling System in Before Operatingsection.If the engine has been running, the pressurized,hot coolant can escape and cause burns.• Do not open the radiator cap when the engine isrunning.• Use a rag when opening the radiator cap, andopen the cap slowly to allow steam to escape.Caution2. Each day after operation, clean debris from the radiatorgrille. Clean more frequently in dusty and dirtyconditions.A. Move seat forward as far as possible.B. Remove upper and lower grille assemblies (Fig. 42).12Figure 421. Upper grille 2. Lower grilleC. Use compressed air to clean the grilles and removedebris from grille mounting areas.D. Install grilles after cleaning, lower and lock seat inposition.3. Every 100 hours operation, clean the radiator andhydraulic cooler fins. Clean more frequently in dustyand dirty conditions.A. Use procedures in step 2, items A–C.B. Unlatch latch handles on both sides and removeradiator cowl and grille support (Fig. 43).21 3Figure 431. Latch handles2. Radiator cowl3. Grille supportC. Remove wing nuts securing top of oil cooler toupper radiator support and pivot top of oil cooleraway from radiator (Fig. 44). |
This manual is suitable for:
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved