Toro 30582 Operator's Manual

Also see for 30582 Groundsmaster 580-D: Operator's manual

35MaintenanceNote: Determine the left and right sides of the machine from the normal operating position.Recommended Maintenance ScheduleMaintenance ServiceInterval Maintenance ProcedureAfter first 10 hours• Check the fan and alternator belt adjustment.• Torque the wheel lug nuts.• Check the cutting unit drive belt adjustment.After first 50 hours• Change the engine oil and replace the filter.• Replace the hydraulic filter.• Torque cylinder head bolts and adjust valves.• Check the engine RPM (at idle and full throttle).• Change the planetary gear drive fluid.Every 50 hours• Lubricate all grease fittings.• Inspect the air filter, dust cup, and baffle.• Clean under the cutting unit belt covers.• Check the cutting unit drive belt adjustment.Every 100 hours• Change the engine oil and replace the filter.• Check the fan and alternator belt tension.• Inspect the cooling system hoses.Every 200 hours • Service the air filter.• Torque the wheel lug nuts.Every 400 hours• Replace the fuel/water separator filter and the fuel filter.• Check the battery level and cable connections.• Replace the hydraulic filter.• Adjust valves.• Check the engine RPM (at idle and full throttle).• Inspect and adjust fuel injection nozzlesEvery 800 hours • Change the planetary gear drive fluid.• Check the rear wheel toe-in.Every 1000 hours orevery 2 years,whichever occurs first• Change the brake fluid.• Change the injection pump filter.• Change the thermostat.• Replace the safety switches.• Flush the cooling system and replace the hoses.• Drain/flush the fuel tank.• Change the hydraulic oil.• Torque cylinder head bolts.Important Refer to your engine operator’s manual for additional maintenance procedures.

/ 64

This manual is suitable for:

30582 Groundsmaster 580-D Groundsmaster 580-D 30583

Toro 30582 Operator's Manual

Product

Learn More

Legal