Toro 30582 Operator's Manual

Also see for 30582 Groundsmaster 580-D: Operator's manual

21height can be changed to compensate for difference andeither transfer washers from bottom to top to lower unit,or from top to bottom to raise. Transfer an equalnumber of washers at all castor wheel locations to keepcutting unit level—two on front unit, four on outboardunits.Adjusting the Height of CutThe height-of-cut is adjustable from 1 to 5-1/2 in. (25 to140 mm) in 1/2 in. (13 mm) increments. Positioning thecastor wheel axles in the top holes of the castor forks(Fig. 12) allows Low range height-of-cut settings from 1 to4 in. (25 to 102 mm); positioning the castor wheel axles inthe lower holes of the castor forks (Fig. 12) allows Highrange height-of-cut settings from 2-1/2 to 5-1/2 in. (63.5 to140 mm).Figure 121. Start engine, position the machine on a level surface,lower cutting units to a point where castor wheels canbe removed from arms, set lift levers in neutral, setparking brake and shut engine off. Remove ignition keyto prevent accidental startup.2. Position castor wheel axles on all cutting units in thesame hole in the castor forks.3. On the front cutting unit, remove the hairpin cotter andclevis pins from the rear castor pivot arms (Fig. 13).Align the pivot arm holes with selected height–of–cutbracket holes in the deck frames, insert clevis pins andinstall the hairpin cotters (Fig. 13).4312Figure 131. Hairpin cotter2. Clevis pin3. Castor axle mount holes4. Pivot arm4. On all remaining castor wheel assemblies, removelynch pin from castor fork shafts (Fig. 14). Removecastor fork shaft and spacer assembly from the castorarm (Fig. 14). Place spacers onto castor spindle todesired height-of-cut setting and install castor fork shaftin arm (Fig. 9). Install remaining spacers onto shaft andsecure assemblies with the lynch pin (Fig. 14).123Figure 141. Lynch pin2. Spacers3. Washers

/ 64

This manual is suitable for:

30582 Groundsmaster 580-D Groundsmaster 580-D 30583

Toro 30582 Operator's Manual

Product

Learn More

Legal