Problem Possible Cause Corrective Action1. The key was turned to the Start positionbefore the glow plug light turned off.1. Turn the key to the Run position andallow the glow plug light to turn offbefore starting the engine.2. The engine temperature is low. 2. Check the thermostat and replace it ifnecessary.3. The glow plugs are not operating. 3. Check the fuse, glow plugs, and wiring.4. The injection pump timing is incorrect. 4. Contact your Authorized ServiceDealer.5. The injection nozzles are damaged. 5. Contact your Authorized ServiceDealer.There is excessive white smoke in theexhaust.6. The engine has low compression. 6. Contact your Authorized ServiceDealer.1. The engine is under an excessive load. 1. Reduce the ground speed of themachine.2. The engine oil level is either too low ortoo high.2. Either add or drain the engine oil untilthe oil level is at the Full mark.3. The air cleaning system elements aredirty.3. Service the air cleaning systemelements.4. There is dirt or water in the fuel system. 4. Drain and flush the fuel system; addfresh fuel.5. The engine overheats. 5. Check the engine oil level and add oilas needed; also check and service thecoolant system, if necessary.6. There is air in the fuel. 6. Bleed the nozzle and check for airleaks at the fuel hose connections andthe fittings between the fuel tank andthe engine.7. The engine has low compression. 7. Contact your Authorized ServiceDealer.8. The fuel tank vent is restricted. 8. Loosen the cap. If the engine runs withthe cap loosened, replace the cap.9. The injection pump timing is incorrect. 9. Contact your Authorized ServiceDealer.The engine loses power.10.The injection pump is damaged. 10.Contact your Authorized ServiceDealer.1. The parking brake is engaged. 1. Release the parking brake.2. The hydraulic fluid level is low. 2. Add hydraulic fluid to the reservoir.3. The tow valves are open. 3. Close the tow valves.4. The pump and/or motor is damaged. 4. Contact your Authorized ServiceDealer.The machine does not drive.5. The relief valve is damaged. 5. Contact your Authorized ServiceDealer.69