Greensmaster 3250--D Page 5 -- 11 Electrical SystemComponent TestingFor accurate resistance and/or continuity checks, elec-trically disconnect the component being tested from thecircuit (e.g. unplug the ignition switch connector beforedoing a continuity check).NOTE: For engine component testing information, re-fer to the Kubota Workshop Manual.CAUTIONWhen testing electrical components for continu-ity with a multimeter (ohms setting), make surethat power to the circuit has been disconnected.Ignition SwitchThe ignition (key) switch has three (3) positions (OFF,RUN and START). The terminals are marked as shown.The circuitry of the ignition switch is shown in the chartbelow. With the use of a multimeter (ohms setting), theswitch functions may be tested to determine whethercontinuity exists between the various terminals for eachposition. Verify continuity between switch terminals.POSITION CIRCUITOFF NONERUN B + I + A, X + YSTART B + I + SABSYXIFigure 6Figure 7SWITCH LOCK WASHERHEX NUT KEYElectricalSystem
