Greensmaster 3250--DHydraulic System Page 4 -- 78Reel Motor Service1. Rear cover2. Drive gear3. Seal4. Tab washer5. Pressure seal6. Back--up ring7. O--ring8. Body9. Idler gear10. Cap screw (4 used)11. Front flange12. Washer (if equipped)Figure 52743125691011(24 to 32 N--m)215 to 280 in--lb856712Disassembly1. Plug motor ports and clean the outside of the motorthoroughly. After cleaning, remove plugs and drain anyoil out of the motor.2. Use a marker or scribe to make a diagonal markacross the front flange, body and rear cover for reas-sembly purposes (Fig. 53).IMPORTANT: Avoid using excessive clampingpressure on the motor flange to prevent distortingthe casting.3. Clamp mounting flange of motor in a vise with theshaft end down.4. Loosen cap screws on the rear cover.5. Take motor from the vise and remove cap screws.6. Remove front flange from the body, then remove rearcover. Locate and remove dowel pins from body.Figure 53DIAGONAL MARK
