Toro 03540 Reelmaster 5200-D Operator's Manual

Also see for 03540 Reelmaster 5200-D: Operator's manual Operator's manual Operator's manual Operator's manual Service manual

Contents

Figure 51. Floor panel 2. Access panel2. Replace the floor panel fastener with aflange-head bolt (5/16 x 5/8 inch) supplied inloose parts (Figure 5).3. Replace the access panel fastener with aflange-head bolt (5/16 x 3/4 inch) supplied inloose parts (Figure 5).Step4Adjusting the Tire PressureNo Parts RequiredProcedureThe tires are over-inflated for shipping. Therefore,release some of the air to reduce the pressure.Correct air pressure in the front and rear tires is 10to 15 psi (69 to 103 kPa).Important: Maintain even pressure in alltires to ensure uniform contact with the turf.Step5Installing the Cutting UnitsParts needed for this step:5 Cutting unit (sold separately)Procedure1. Remove the cutting units from the cartons.Assemble and adjust the as described in thecutting unit Operator’s Manual.2. If you will be using baskets on the cutting units,use the chart below (Figure 6) to determine thelocations at which you need to mount basketguides to the cutting unit carrier frames. If youwill not be using baskets, proceed to step 4.Figure 63. Mount a basket guide (Figure 7) to theappropriate side of each cutting unit carrierframe (Figure 8) with a bolt (5/16 x 1-3/4inches), flat washer, and lock washer orfasteners previously removed, as shown inFigure 7.16