Sony DWR-R02DN User Manual

Also see for DWR-R01D: User guide Operating instructions Operating instructions Operating instructions

54[Display settings] WindowUse this to specify whether to display certain setting itemsand buttons. When you select the checkboxes of the itemsin each tab and click the [OK] button, the correspondingitems and buttons will be displayed.[Display] tabThis tab allows you to specify whether to display certainitems in the [Device List] window, status viewer, [SimpleStatus Viewer] tab, etc.Number: Select whether to display the receiver channelnumber.Label: Select whether to display the label configured inthe [Receiver CH Label settings] window.GP/CH: Select whether to display the group/channelsettings for reception channels.Frequency: Select whether to display the receptionchannel frequency.RF alert: Select whether to display an alert when the radiowave input level decreases or becomes too high.RF meter: Select whether to display a meter that indicatesthe radio wave input level.QL alert: Select whether to display an alert when thequality of the received data decreases.QL meter: Select whether to display a meter that indicatesthe quality of the received data.Tx Name: Select whether to display the name of thetransmitter.Individual muting/unmuting: Select whether to displaythe audio output status for receiver channels.AF meter: Select whether to display a meter that indicatesthe audio level.AF/Peak alert: Select whether to display AF/PEAK(audio input/peak) alerts.Battery status: Select whether to display the transmitter’sbattery condition.RF power status: Select whether to display thetransmitter’s transmitted power.RF remote status: Select whether to display thetransmitter’s wireless remote control condition.Word sync status: Select whether to display the syncstatus of the signal output from the receiver’s DIGITALOUT connector.Display example for the [Device List] window• Both Label and Tx Name displayed• Only Tx Name displayed (factory default setting)• Only Label displayedDisplay example for the [Property List] tab• Both Number and Label displayed• Only Number displayed (factory default setting)