Sony DWR-R02DN User Manual

Also see for DWR-R01D: User guide Operating instructions Operating instructions Operating instructions

45b Meter iconsThese function identically to the meter icons in the statusviewer.c Property tabsThese consist of the [Utility] tab and tabs for channels 1and 2.For details on the setting items in each tab, see “[Utility]tab” on page 45 and “Channel tabs 1/2” on page 45.d [Close] buttonCloses the [Property] window.[Utility] tabDisplays setting items that are equivalent to those in theUTILITY menu of the receiver.For details on each setting item, refer to the OperatingInstructions supplied with the receiver.Receiver Type: In online mode, this displays the deviceinformation acquired from the receiver and cannot bechanged. The device information can be changed in offlinemode.Receiver Model: In online mode, this displays thefrequency band acquired from the receiver and cannot bechanged. The frequency band can be changed in offlinemode. Specify a frequency band that corresponds to theactual device.Receiver Name: Sets a name for the receiver.Band Block: Selects the frequency band to use (the largestis 72 MHz).This function is not supported by the DWR-R01D andDWR-R02D.Band: Selects the frequency band to use.ANT ATT: Sets the attenuator for the receiver’s antennainput.ANT DC Output: Sets the DC power supply for theantennas connected to the receiver’s ANTENNA a/b INconnectors.Sync Source: Sets the sync signal source for the receiver.Delay Adjust: Selects whether to correct differences inaudio delay time that may occur between receiver channels1 and 2.Alert function settings: Specifies the conditions underwhich to light the ALERT indicator on the receiver. Youcan select the following conditions as triggers for lightingthe ALERT indicator.• RF low (RF level too low)• RF over (RF level too high)• QL low (QL too low)• AF Peak (audio output level too high)• Transmitter Battery low (remaining battery ontransmitter is low)• Encryption unmatch (password or encryption key for theencrypted communication function does not match)• External word sync unlock (external word clock signalnot synchronized)• Code mode unmatch (codec modes of transmitters andreceivers do not match)If lighting of the ALERT indicator is disabled for an item,warning messages will not be displayed in the [MessageLog] tab or in the alert list under the [RF Chart Grapher]tab of Wireless Studio for that item. In addition, such itemswill not be recorded in the log file.QL Alert SENS: Specifies the level at which the qualityof the received signal is determined to be low. If the thequality of the received signal drops below the levelspecified here, the ALERT indicator of the digital wirelessreceiver lights.The QL Alert SENS function is available for the followingreceiver versions.DWR-R01D: Version 1.29 or laterDWR-R02D: Version 1.09 or laterDWR-R02DN: Version 1.14 or laterChannel tabs 1/2Displays setting items that are equivalent to those in theRECEIVER, TRANSMITTER, and RF REMOTE menusof the receiver.For details on the setting items in each menu, refer to theOperating Instructions supplied with the receiver.NoteNoteNote