Sony DWR-R02DN User Manual

Also see for DWR-R01D: User guide Operating instructions Operating instructions Operating instructions

13Menus[File] menuThis menu allows you to load existing setting files andsave settings.The [File] menu has the following commands.The [New], [Open], and [Save] commands can only beused in offline mode.New: Creates a new settings file.Open: Opens a setting file.Save: Saves the current settings to a setting file that isalready open by overwriting the contents of the file. Forsetting files that are still unnamed, this command can beused in the same way as the [Save as] command to add aname to a setting file before saving it.Save as: Adds a name to the current settings and savesthem to a setting file (file extension: dwl2).Exit: Exits the Wireless Studio software.[View] menuThis menu allows you to show or hide each window, andrestore the size and layout of each window to their defaultstate from immediately after installation.The [View] menu has the following commands:Default Size and Layout: Restores the size and layout ofwindows to their default state from immediately afterinstallation.Device List: Shows or hides the [Device List].Status Viewer: Shows or hides the status viewer.Message Log: Shows or hides the [Message Log] tab ofthe sub window.Property List: Shows or hides the [Property List] tab ofthe sub window.RF Chart Grapher: Shows or hides the [RF ChartGrapher] tab of the sub window.RF Chart Analyzer: Shows or hides the [RF ChartAnalyzer] tab of the sub window.Spectrum Analyzer: Shows or hides the [SpectrumAnalyzer] tab of the sub window.Simple Status Viewer: Shows or hides the [Simple StatusViewer] tab of the sub window.[Device] menuThis menu allows you to make network connectionsettings for each device.The [Device] menu has the following commands:Online monitoring and control: Switches betweenonline mode and offline mode. The system is in onlinemode when the check mark appears next to the command,and offline mode when the check mark is cleared.Load settings: Applies the setting values configured inWireless Studio to the receivers and transmitters (availablein offline mode only).For details, see “Using Settings Files” on page 21.Add a new device: Opens the [Add a new device]window. Use this when entering IP addresses to adddevices to the device window manually.For details, see “Manually adding a receiver/RMU-01 tothe [Device List] window” on page 28.Search devices: Automatically detects the receivers andRMU-01 units on the same subnet (available in onlinemode only).Omit IP address list: Opens the [Omit IP address list]window (available in offline mode only).For details, see “[Omit IP address list] Window” onpage 52.Setting lock: Opens the [Setting lock] window. Use this todisable or enable the modification of receiver andtransmitter settings from Wireless Studio.For details, see “[Setting lock] Window” on page 52.Pairing wizard: Opens the [Pairing Wizard] dialog box.Use this to pair receiver channels and transmitters.For details, see “Pairing Receiver Channels andTransmitters” on page 18.Channel Plan Adviser: Opens the [Channel Plan Adviser]window. Use this to select channel plans using [ChannelPlan Adviser].For details, see “Selecting Channel Plans” on page 16and “[Channel Plan Adviser] Window” on page 47.[Option] menuThe [Option] menu has the following commands:Receiver CH Label settings: Opens the [Receiver CHLabel settings] window. Use this to configure labels foreach receiver channel.For details, see “[Receiver CH Label settings] Window”on page 53.GP/CH Display settings: Opens the [GP/CH displaysetting] window. Use this to configure the settings for thegroups and channels displayed on Wireless Studio.For details, see “[GP/CH display setting] Window” onpage 53.Note