Sony DWR-R02DN User Manual

Also see for DWR-R01D: User guide Operating instructions Operating instructions Operating instructions

44G RF (radio wave) level alertLights red when the radio wave input level decreases.When the radio wave input level is high, this lights yellow.H AF/PEAK (audio input/peak) alertLights red when the level of audio signal input to the transmitterexceeds the transmitter’s maximum input level setting.I Audio output control/indicatorIndicates the status of audio output for the receiver channel.Clicking the icon toggles the status of audio output.: Audio output is enabled. Clicking the icon will enablemuting of the audio output.: Audio output muting is enabled. Clicking the iconwill disable muting of the audio output.This setting can only be changed if the [Individual muting/unmuting] checkbox is selected in the [Display settings]window.For details, see “[Display settings] Window” on page 54.J AF level meterIndicates the level of the audio signal input to thetransmitter according to four levels.The way the meter lights will vary depending on the inputlevel setting of the transmitter.• When the INPUT LEVEL settings of the transmitter isMIC levelUnlit: The input level of the audio signal is less than–36 dBFs.1 bar lit: The input level of the audio signal is –36 dBFsor more and less than –20 dBFs.2 bars lit: The input level of the audio signal is –20 dBFsor more and less than –3 dBFs.3 bars lit: The input level of the audio signal is –3 dBFsor more.• When the INPUT LEVEL settings of the transmitter isLINE levelUnlit: The input level of the audio signal is less than–20 dBFs.1 bar lit: The input level of the audio signal is –20 dBFsor more and less than –10 dBFs.2 bars lit: The input level of the audio signal is -10 dBFsor more and less than –3 dBFs.3 bars lit: The input level of the audio signal is –3 dBFsor more.K Battery condition displayIndicates the transmitter’s battery condition.Setup WindowsWireless Studio includes the following setup windows:• [Property] window• [Channel Plan Adviser] window• [Omit IP address list] window• [Setting lock] window• [Receiver CH Label settings] window• [GP/CH display setting] window• [Display settings] window• [Other settings] window• [Startup settings] window• [Region setting] window[Property] WindowThis window allows you to view and change settings forreceivers and their paired transmitters.a [Unlock Settings] / [Lock Settings] buttonWhen setting modification is disabled due to the [Settinglock] function, click this button and enter the password totemporarily enable setting modification.Close the [Property] window or click the button again torelock settings.For details on the [Setting lock] function, see “[Settinglock] Window” on page 52.Note1234