Sony Betacam SX DNW-A100 Maintenance Manual

4-77DNW-A100/A50/A45DNW-A100P/A50P/A45PExample of display and operation (D3)DISK MAINTENANCE MODED3:INSTALLATION[ID-00] LA136291 (MARK)[ID-01] LA046473 ( )INITIALIZE all the HDDsmarked above at a time.------------------------Confirm the serial No.!!Select all HDDs replacedwhile showing (MARK)._ID-00_ LA136291Superimpose picture Time data display areaDISK MAINTENANCE MODED3:INSTALLATION[ID-00] LA136291 ( )[ID-01] LA046473 ( )INITIALIZE all the HDDsmarked above at a time.------------------------Confirm the serial No.!!Select all HDDs replacedwhile showing (MARK).**0 [JOG] + DIAL(2)_ID-00_ MARKDISK MAINTENANCE MODED3:INSTALLATION[ID-00] LA136291 (MARK)[ID-01] LA046473 ( )Executing ...------------------------Confirm the serial No.!!Select all HDDs replacedwhile showing (MARK).INITIALIZEDISK MAINTENANCE MODED3:INSTALLATION[ID-00] LA136291 (MARK)[ID-01] LA046473 ( )INITIALIZE all the HDDsmarked above at a time.------------------------Confirm the serial No.!!Select all HDDs replacedwhile showing (MARK).**0 [SET]D3- EXECUTINGDISK MAINTENANCE MODED3:INSTALLATION[ID-00] LA136291 (DONE)[ID-01] LA046473 ( )------------------------All the marked HDDs havebeen initialized.*0_ID-00_ DONE_ID-01_ LA0464730(omitted)04-3. DISK Maintenance Mode (M1)4-3-5. HDD Installation Menu (D3)4-3-6. BLACK File Installation Menu (D4)4-3-6. BLACK File Installation Menu (D4)The D4 : BLACK INSTALLATION menu is used when aBLACK file is manually written in the zone of the harddisk that is set to the enable state by this unit.(This menu is applied to the unit in which the SSX ROMversion is 3.10 or later.)nIn general, a BLACK file is automatically created whenF5: DELETE ALL FILE is executed in a disk file manage-ment menu.(For details of the disk file management menu, refer toSection 7-4 in the Operation Manual.)The D4 : BLACK INSTALLATION menu may be select-ed after the maintenance mode is activated or may beautomatically activated after the power is turned on.In the following three cases, the D4: BLACK INSTALLA-TION menu is automatically activated after the power isturned on.. When the connected BKNW-116 is first used afterfactory-shipping(The factory-shipped BKNW-116 has no BLACK file.). When the zone size of BKNW-116 is changed in the D5: ZONE CONFIGURATION menu of the maintenancemode. When the zone is changed from FULL to HALF-1 orHALF-2 in the emergency zone configuration menudisplayed in case that system error D8 (sub-error code 84: hardware error of hard disk) occurs(For details of the emergency zone configuration menu,refer to the Operation Manual.)BLACK fileThe BLACK file is required when editing is performedusing a nonlinear editing machine (DNE-50/700). Theheader based on this BLACK file is indispensable toreproduce the program created during editing.The BLACK file itself cannot be deleted.