Sony Betacam SX DNW-A100 Maintenance Manual

1-8 DNW-A100/A50/A45DNW-A100P/A50P/A45P21. Slide the unit in and out from the rack about threetimes and check that the slide rails move smoothly.If they are not smoothly, demount the unit and go backto “Attaching outer rails” (step 12).cWhen demounting the unit, carry it by the two personsor more.nThis unit does not have the feet in this operation.Put down this unit on the floor or other, being carefulnot to give a shock to it.22. Fix the unit to the rack with two screws and twoornamental washers.Tightening torque: 120 x 10_2 N . m {12.2 kgf . cm}1-6. Rack Mounting. Mounting in rackcBe sure to carry the unit by the two persons or more.17. Slide each ball retainer of intermediate rails on bothsides (left and right) in the direction of the arrow.18. Pull equal length of each rail on both sides out.19. Lift the unit holding the handles, slowly insert theinner rails into the intermediate rails.20. While pressing the stoppers on the both sides (left andright), slowly push the unit into the rack.nBe careful not to catch your finger or hand in rackmount rail.Intermediate railBall retainerStopperStopperIntermediate railInner railOrnamental washerRK5 x 14Ornamental washerRK5 x 14