Menu
Sony BKP-5090 Installation And Maintenance Manual
                                                                                                                                          | |
2-8 (E) BKP-50902-2-5. VA Output Level ConfirmationEquipment : OscilloscopePreparation:. Extend VA-163 board with EX-464 board.Confirmation:1. WHITE BAL switch (on the side panel) → PRST2. Set the DISP switch (on the side panel) from OFF toMENU while holding down the MENU SEL switch(on the front panel).3. Set the menu as follows.MENU : System configPAGE : PR/VA/Test (S3)ITEM : Test → 14. Confirm the G white level.Test Point : TP52 (GND:GND (A))/Extension board(extending VA-163)Specification : A = 670 ±2 mV(Oscilloscope)5. Confirm the R white level.Test Point : TP54 (GND:GND (A))/Extension board(extending VA-163)Specification : A = 670 ±40 mV6. Confirm the B white level.Test Point : TP50 (GND:GND (A))/Extension board(extending VA-163)Specification : A = 670 ±40 mV7. If the specification is not satisfied, carry out Section4-3-7 “Test 1 Adjustment” in the BVP-550/550Pmaintenance manual and readjust each level for theabove specifications.Resetting after the Confirmation:. Set the menu as follows.MENU : System configPAGE : PR/VA/Test (S3)ITEM : Test → OffA2-2-6. Pre Knee AdjustmentEquipment : Oscilloscope, Waveform monitorPreparation:. Extend VA-163 board with EX-464 board.Iris of the lens : CLOSEAdjustment Procedures:1. Set the DISP switch (on the side panel) from OFF toMENU while holding down the MENU SEL switch(on the front panel).2. Set the menu as follows.MENU : PaintPAGE : W.Clip/Knee (P6)ITEM : Knee → On3. Set the RGB/ENC switch (on the side panel) to ENC.4. Set the GAIN switch (on the side panel) to M (9 dB).5. Set the WHITE BAL switch (on the side panel) toPRST.6. Set the menu as follows.MENU : System configPAGE : PreKnee/Zebra (S4)ITEM : Test → 27. Set the menu as follows, and adjust the pre knee 1 forG by using the MENU SEL switch.Test Point : TP52 (GND:GND (A))/Extension board (extending VA-163)Adjustment Point:MENU : System configPAGE : PreKnee/Zebra (S4)ITEM : PreKnee1[G]Specification : A = 1.80 ±0.01 V p-p(Oscilloscope)2-2. Adjustments on BVP-550/550P2-2-5. VA Output Level Confirmation2-2-6. Pre Knee AdjustmentA |
Related manuals for Sony BKP-5090
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved