Siemens SINUMERIK Series Operating Manual

Also see for SINUMERIK 828D Turning: Diagnostic manual Function manual Equipment manual Programming manual Operating manual

Parameter Description UnitFD - (only forthrough drilling"yes")Reduced feedrate for through drilling referred to drilling feedrate F %Feedrate for through drilling (ShopTurn) mm/min ormm/rev.Feedrate for through drilling (G code) Distance/min or dis‐tance/revDT - (only forthrough drilling"no")● Dwell time at final depth in seconds● Dwell time at final depth in revolutionssrevParameters in the "Input simple" modeG code program parameters ShopMill program parametersInput ● simpleRP Retraction plane mm T Tool nameD Cutting edge numberF Feedrate mm/minmm/revS / V Spindle speed or constantcutting raterpmm/minParameter DescriptionMachining position(only for G code)● Single positionDrill hole at programmed position● Position patternPosition with MCALLZ0 (only for G code) Reference point Z mmDrilling depth ● Shank (drilling depth in relation to the shank)The drill is inserted into the workpiece until the drill shank reaches the valueprogrammed for Z1. The angle entered in the tool list is taken into account.● Tip (drilling depth in relation to the tip)The drill is inserted into the workpiece until the drill tip reaches the value programmedfor Z1.Z1 Drilling depth (abs) or drilling depth in relation to Z0 (inc)It is inserted into the workpiece until it reaches Z1.mmDT ● Dwell time (at final drilling depth) in seconds● Dwell time (at final drilling depth) in revolutionssrevProgramming technological functions (cycles)10.1 DrillingMilling376 Operating Manual, 08/2018, 6FC5398-7CP41-0BA0