Siemens SINUMERIK Series Operating Manual

Also see for SINUMERIK 828D Turning: Diagnostic manual Function manual Equipment manual Programming manual Operating manual

Display MeaningBlue-green font "G2" or "G3" motion commandGray font CommentMachine manufacturerYou can define further highlight colors in the "sleditorwidget.ini" configuration file.Please refer to the machine manufacturer's instructions.Editing a program directlyIn the Reset state, you can edit the current program directly.1. Press the key.2. Place the cursor at the relevant position and edit the program block.Direct editing is only possible for G code blocks in the NC memory, notfor external execution.3. Press the key to exit the program and the edit mode again.See alsoSetting for automatic mode (Page 267)6.4.2 Displaying a basic blockIf you want precise information about axis positions and important G functions during testingor program execution, you can call up the basic block display. This is how you check, whenusing cycles, for example, whether the machine is actually traversing.Positions programmed by means of variables or R parameters are resolved in the basic blockdisplay and replaced by the variable value.You can use the basic block display both in test mode and when machining the workpiece onthe machine. All G code commands that initiate a function on the machine are displayed in the"Basic Blocks" window for the currently active program block:● Absolute axis positions● G functions for the first G group● Other modal G functionsMachining the workpiece6.4 Displaying the current program blockMillingOperating Manual, 08/2018, 6FC5398-7CP41-0BA0 195