Siemens SINUMERIK Series Operating Manual

Also see for SINUMERIK 828D Turning: Diagnostic manual Function manual Equipment manual Programming manual Operating manual

6.17 Setting for automatic modeBefore machining a workpiece, you can test the program in order to identify programmingerrors at an early stage. Use the dry run feedrate for this purpose.You have the option of additionally limiting the traversing speed so that when running-in a newprogram with rapid traverse, no undesirably high traversing speeds occur.Dry run feedrateIf you selected "DRY run feedrate" under program control, then the value entered in "Dry runfreedrate DRY” replaces the programmed feedrate when executing/machining.Reduced rapid traverseIf you selected “RG0 reduced rapid traverse" under program control, then rapid traverse isreduced to the percentage value entered in "reduced rapid traverse RG0”.Displaying measurement resultsUsing an MMC command, measurement results can be displayed in a part program:The following settings are possible:● When it reaches the command, the control automatically jumps to the "Machine" operatingarea and the window with the measurement results is displayed● The window with the measurement results is opened by pressing the "Measurement result"softkey.Recording machining timesTo provide support when creating and optimizing a program, you have the option of displayingthe machining times.You define whether the time is determined while the workpiece is being machined (i.e. if thefunction is energized).● OffMachining times are not determined when machining a workpiece. No machining times aredetermined.● Non-modalThe machining times are determined for each traversing block of a main program.Note: You also have the option of displaying the cumulative times for blocks.Please observe the information provided by the machine manufacturer.● Block-by-blockMachining times are determined for all blocks.NoteUtilization of resourcesThe more machining times are displayed, the more resources are utilized.More machining times are determined and saved with the non-modal setting than with theblock-by-block setting.Machining the workpiece6.17 Setting for automatic modeMillingOperating Manual, 08/2018, 6FC5398-7CP41-0BA0 267