Siemens SINUMERIK 840D Series Diagnostics Manual

Also see for SINUMERIK 810D: Programming manual Programming manual Programming manual Function manual Function manual

1 Alarms 11.021-586 Siemens AG, 2002. All rights reservedSINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 EditionNo. 91Explanation Start continuation of interpreter processing. (internal preprocessing stop)Not allowed if -Remedy -No. 92Explanation Save interlock for dataNot allowed if The channel is not in the "stopped" stateRemedy -No. 93Explanation Activate user data, e.g. via MMC; newly modified tool lengths are effective immediately inthe running program.Not allowed if 1. The channel is not in the "stopped" state2. The channel is stopped and the current block cannot be reorganized.Remedy > Press the Stop/Single-Block/ Reset/StopAtEnd (Automatic) key> Activate a block change until the NC block can be reorganized.No. 94Explanation Write the user PLC version into the version fileNot allowed if -Remedy -No. 95Explanation Switch measuring systems (PI command)Not allowed if -Remedy -No. 96Explanation Shut down system (VDI signal)Not allowed if -Remedy -No. 97Explanation Activate block search program invocation in mode 5. This mode simulates the blocksearch in which the program under "Program test operation" is processed as far as thetarget of the block search.Not allowed if -Remedy -No. 98Explanation Extended stop and retractNot allowed if -Remedy -No. 99Explanation Block search (general) is currently being activated (negative acknowledgement may beoutput for PI service).Not allowed if -Remedy -